ALEiens Homebrew Club

Spreading the Joys of Home Brewing Throughout Philadelphia and the Universe!

I had my kegs cut and welded by my uncle while he did my frame as well. Except I didnt pay attention to the half 1" coupler and it was welded in backwards. I plan to cut it out myself, but I dont feel liek driving back out to Downingtown to get one piece welded. So does anyone know of someone who can quickly do one coupling?

Views: 52

Reply to This

Replies to This Discussion

I used these guys and was very happy with the result (three fittings welded into my keggle very nicely)

Elonis Welding
1088 Old Bristol Pike, Morrisville, PA
(215) 736-0646‎
Eivind, did they cut the keg too or just weld?
Welding only (it was pre cut from PHB, and I drilled the holes myself) but I think they can do that as well.
hey Eivind. how much did Elonis Welding charge for this? It was 3 fitting into one keg?
Hey Jeff,

I think I paid $125 for three fittings welded into one keg with some kind of gas (Ardon?) "refinement" to help make it real smooth and easy to clean on the inside.

He did a nice job, and they were a pleasure to deal with.
Justin, You might consider cutting it off grinding it down and using a S.S. union, rubber Oring, washer and nut. I don`t know if this will help with your set up but that`s what I did with my HLT. Good Luck.

RSS

UPCOMING MEETINGS

---------------

APRIL MEETING:

4/30/2019

Iron Brewer Round 2

---------------

MAY MEETING:

5/28/2019

TBD

---------------

JUNE MEETING:

6/25/2019

TBD

---------------

Events

The Hulmeville Inn Feed

© 2019   Created by Jeff Louella.   Powered by

Badges  |  Report an Issue  |  Terms of Service